Asante-technologies 10NIC-PCITM Manual do Utilizador descarregar pdf (Página 40)

Page 4-6

Troubleshooting

PC Diagnostic Program

To run the diagnostic program on your PC, follow the procedure below.

Insert the Asanté Driver Disk into drive A.

At the DOS prompt, type the following command:

A:\UTILITY\DIAGPCI

Press Enter.

A warning message window appears that you should read.

Press C to continue (or ESC to abort the diagnostic pro-

gram).

The diagnostic program searches for adapters installed in

your computer system. A screen appears showing you the

adapters found.

Select the appropriate adapter from the list and press

Enter.

Use the UP or DOWN arrow key to make a selection.

A screen appears showing you the following menu options:

❏ Loopback Tests — tests the adapter by sending packets

across the components for loopback tests.

❏ Adapter Status — displays the adapter configuration

information such as PCI slot number, base I/O address,

interrupt line, media type, network speed, and Ethernet

node address.

❏ Go Back to previous screen

Select Loopback Tests and press Enter.

The program runs a series of tests. Their results are dis-

played for you after each test with a PASSED or FAILED indi-

cation.

When the tests ﬁnish, verify the results to make sure that

all tests passed.

If a test fails, check that the adapter is seated properly in a

PCI bus-mastering slot or try installing the adapter in a dif-

ferent PCI slot and run the tests again. Make sure your

computers’s power cord is ﬁrst unplugged before wiggling

or removing any adapter cards!

Press any key to return to the menu option screen.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 49 50

Sem comentários

Asante-technologies 10NIC-PCITM Manual do Utilizador Página 40